Cisco Industrial Networking Specialist Certification exam measures your skills of Managing Industrial Networks with Cisco Networking Technologies and DumpsSchool Cisco
200-401 exam questions are most useful to get these skills. DumpsSchool 200-401 exam questions come with practice questions to provide you knowledge of the OSI layers of IP networks, as well as networking devices.
Try it Latest DumpsSchool 200-401 Exam dumps. Buy Full File here: https://www.dumpsschool.com/200-401-exam-dumps.html (63 As Dumps)
Download the DumpsSchool 200-401 braindumps from Google Drive: https://drive.google.com/file/d/1BxqMTHZCj6fCD6Tk62D4_sFnUlLm-DXS/view (FREE VERSION!!!)
Question No. 1
Refer to the exhibit. What are three traffic and interconnection requirements for the devices in the exhibit? (Choose three.)
A. The EtherNet/IP drive connections are in a high-voltage area and need protection from electromagnetic noise, soshielded cable that is rated for 600 Vis advised.
B. EtherNet/IP devices such as the controller, drive, VoIP phone, and IP camera should be in the same VLAN.
C. CIP traffic has the highest bandwidth requirement so it needs the highest QoS setting.
D. EtherNet/IP drive traffic has high sensitivity to random drops, latency, and jitter.
E. Real-time motion control and VoIP traffic can share the same VLAN with the proper QoS setting.
F. IEEE1588 and PTP are important for ensuring real-time synchronization.
A, D, F Answer:
Question No. 2
Which three of the following components must be elected before the Spanning Tree Protocol can converge in a switched LAN? (Choose three.)
A. designated ports
B. duplex operating mode
C. fast mode ports
D. root bridge
E. root ports
F. BDPU priority
A, D, E Answer:
Question No. 3
What is a reason to use privileged EXEC mode on an industrial switch?
A. to verify commands that you have entered
B. to change terminal settings
C. to configure VLAN parameters
D. to configure parameters that apply to the entire switch
Question No. 4
What is the purpose of a time domain reflectometer?
A. It uses pulses to locate and test for sheath faults, damaged conductors, loose connectors, splices, bridge taps, split pairs, and other problems.
B. It opens shorts and pinholes in cable shielding.
C. It correlates the returned light pulses with a location in the fiber.
D. It opens kinks and mismatched cable connectors.
Question No. 5
Refer to the exhibit. The output that is shown is generated at an industrial switch. Which three statements are true? (Choose three.)
A. All ports will be in a state of discarding, learning, or forwarding.
B. Thirty VLANs have been configured on this switch.
C. The bridge priority is lower than the default value for spanning tree.
D. All interfaces that are shown are on shared media.
E. All designated ports are in a forwarding state.
F. This switch must be the root bridge for all VLANs on this switch.
A, C, E Answer:
Question No. 6
Which two reasons make mesh bonding systems most effective? (Choose two.)
A. cover wide areas
B. provide additional strength to floor structures
C. provide low-impedance noise-equalizing paths
D. create equipotentialgrounding systems
E. most cost-effective approach
C, D Answer:
200-401 Dumps Google Drive: (Limited Version!!!)
Exam Vendor: Cisco dumps